Product Overview
Introducing the BFM......you guys wanted it so this is it. A high capacity magazine body for your TX22.
READ ALL OF THIS BEFORE BUYING
This is a complete DIY product! It does not come with a spring and you must use one of your existing TX22 10 or 16rnd mags to completely build it.
This is a reinforced glass fiber version of the original BFM. It is very impact and heat resistant. The only downside is that the bottom plug must be made out of the standard material. Glass fiber is very strong and does not make for a very good plug where the tabs need to bend a little. The texture is also very different which can be described as slight rough satin. Being such, this introduces the factor of friction. The body should be lubed very well with a spray such as Rem Oil and used with one of our followers. This version of the BFM should be good up to 200*F heat exposure and very impact resistant.
Since this is a prototype it has not been rigorously tested.
The spring that we use is a Wolf 65064 which is commonly found. It will need to be trimmed down to the appropriate length that YOU decide what works best for you. Use caution in removing the floor plate as the tabs may crack if you apply too much force. You will receive a regular base plate and a HT baseplate. For the HT base plate, we recommend using screws to hod it in place. The tabs will eventually snap on the HT baseplate but the screws should keep it in place. Again, this is DIY.
Due to how large this item is. Shipping is built into the price. Since this is not actually a magazine. There are no shipping restrictions except for HI and CA.
